PENGARUH POLYVINYL ACETATE (PVAC) TERHADAP KUAT TEKAN MATERIAL NANOKOMPOSIT DARI TANDAN KELAPA SAWIT

Ida Sriyanti, Leni Marlina

Abstract


The aims is to determine the effect of filler Mg(OH)2 against pressing pressure nanocomposite material bunches of palm oil that has been made. The method used in this study is a simple method of mixing and hot press method. Presses temperatures used in this study was 100 ° C, the time press was 15 minutes and pressing pressure was 50 MPa. To determine the feasibility of the nanocomposite material has been made by characterization with  the pressing test. From the pressing test results obtained to the highest pressing presure  when the composition ratio of waste oil palm empty fruit bunches (TTKS), PVAc, Nonosilika is 13:2 : 0,75 (gr) with  the pressing presure as big as 55 MPa, while the composition ratio of the composite without giving PVAc obtained pressing presure  as big as  22.5 MPa. This research method is very useful to produce a material that is strong and light nanocomposite in a short time interval.

Keywords


nanocomposite; waste oil palm empty fruit bunches; nanosilika



DOI: https://doi.org/10.36706/jipf.v1i1.1266

Refbacks

  • There are currently no refbacks.


Copyright (c)



Jurnal Inovasi dan Pembelajaran Fisika
Program Sarjana Pendidikan Fisika
Fakultas Keguruan dan Ilmu Pendidikan
Universitas Sriwijaya
Jl. Raya Palembang-Prabumulih KM 32 Indralaya
Ogan Ilir, Indonesia
email: jipf@fkip.unsri.ac.id.

p-ISSN: 2355-7109
e-ISSN : 2657-0971

Jurnal Inovasi dan Pembelajaran Fisika is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License

 

Indexed in:

 

Recommended Tools :

  

 


Flag CounterView My Stats